Prints fantastic in AMS TPU. Works great, only constructive criticism, you may want to add a slight fillet on the edge that of the face that meets the build plate, it would soften the edge that rubs along the controller. Otherwise, amazing simple fix. thanks!

absolutely love the model. I modified the print profile a few ways, I scaled it up a bit, used fuzzy skin to hide the layer lines, and printed with her leaning back about 30 degrees. the lean reduced the supports needed on the visible parts of the model and further obscured the visible layer lines. turned out great. if I print it again, I would probably reduce the layer height and pull the fuzzy skin thickness down a hair. but the result looks good for a first try.