Works in bricks. In concrete it was somehow too big, even though I used same drill for both. I noticed original ones are a bit thinner. So if you can make V2, make it a bit thinner.

Great print. For the small attachment I used 3 magnets. The bigger ones required around 18 - 24.

Great print. Works with 4 thick 240 volt cables. No issues.

Great print. Printed 3 in one go. I attached it on the drawer. Now scizors will be easy to find.

Great. Fits perfectly.

No big issues in default settings.

Great. Printed in ABS and TPU. Feels strong. Even with force the clip did not break. It fits well with original peak design.

Good. Looks like ironing is not enabled. Other than this no issues.

Printed perfectly. Though I thought it will be twice smaller. Didn't notice when printing from the phone app.

Great. Default settings used.

Great. Printed with default settings.

Perfect. Printed with default settings.

Fits well, printed without any flaws.

In the end it did not fit my drills. Holes should be bigger. I had to use it for my other drill.

Great. Does its job. The sticks are wobbly though. They should have some extra support not to fall of.

Perfect. Works as intended.

Great but the hight is not 8 cm as the name suggests. I would change it. Quality was better in PLA. It did print in PETG as well but not as great.

I print two boxes. Both had same issue. The holding pins are too tight to go through skadis board. A bit sanding is required. When adding holding pin cover the box does not close. But they are not required (didn't use on black box). You can see a difference. If this would be corrected I would give 5/5.

A bit helpfull. Not as much as I thought it would. I'm not able to push it far. Probably depends on toothpaste.

Great. Fits perfectly.