OsMakerSpace

HaughtyGrayAlien

Holder for Tupperware lids (for kitchen organisation).Big and small versions.Should fit most kinds of lids, but obviously YMMV.Can be printed without any supports if your printer can handle a little bridging (I printed the ones in the pictures without any supports just fine).

Tupperware Lid Holders (Kitchen Organiser)

Organize

Tekk3D

<h2>90° Verbinder</h2>&nbsp;für Platten über einer dicke von 8mmDu benötigst ledliglich eine M6x25 Innensechskantschraube und eine M6 Mutter<h2>90° Connector</h2>For Plates Above 8mm thicknessYou just need a M6x25 screw and a m6 Nut for 8-14mm Plates

Plate Connector 90 Degree/90 Grad Plattenverbinder

Brackets

mladen88

21.06.24: added smaller Version that fits on A1 mini&nbsp;I made this Container/Storage for the cable organizer/winder by squinn. This size fits 7 medium sized cable organizers or in my case 5 medium, 1 large and 1 small.&nbsp;In this version I only added the honeycomb pattern.Link to “old” version: <a target="_blank" href="https://makerworld.com/de/models/62199#profileId-64719" rel="nofollow noopener">https://makerworld.com/de/models/62199#profileId-64719</a>Skadis version: <a target="_blank" href="https://makerworld.com/en/models/170648#profileId-187318" rel="nofollow noopener">https://makerworld.com/en/models/170648#profileId-187318</a>Link to the Cable Organizer/Winder by squinn: <a target="_blank" href="https://makerworld.com/de/models/13849#profileId-13650" rel="nofollow noopener">https://makerworld.com/de/models/13849#profileId-13650</a>&nbsp;&nbsp;

Storage Box for Portable Cable Organizer V2

Cables

squinn

A handy tool to help with soldering, de-soldering, or other tasks where you need a steady third hand.  This is a fully printable design, so no other hardware is required.  The clamping mechanism can be adjusted to accommodate boards up to 20 cm in length, and can be installed facing either direction.&nbsp;All STLs are oriented as they should be for optimum printing, which have been designed with the layer lines in mind to result in a strong print (and no supports or brim should be required).