Excellent sculpt and profile. minor sagging on the underside, but nothing you'll see in use.

Excellent. Easy print, press fit, and perfect fit. Boosted. Any chance of a compatible Pro-Acryl version? I know the spacing of the slots wouldn't mesh, but just having the match and lock together would be great.

Even after working it quite a bit, the movement isn't very smooth, and it puts a bit if strain in the single-axis joints, since they don't smoothly transfer torque to the swivels or ball joint. Maybe consider a hair more play to in the various joints for smoother movement or just move to all ball joints.

Nice box, lid fits well. the template for the felt could be better. Maybe the actual shape you want to cut? But I didn't hold that against the rating, since adding felt isn't really part of the print profile

Good sticks. Prinet well. Sturdy enough, but still lightweight. Should really add numbers so you can see when looking at what you're measuring instead of have to look away to count sections to the end.

Nice dragon. printed well with surprisingly few supports.

The default profile is VERY small, and I recommend downloading and resizing in slicer, rsther than just printing, unless you have very small objects to hang, but the design is good.

Edit: Adjusted Rating for corrected file Decent design, but two of the magnetic plates (40&50mm) have the magnetic holes inset only 1mm when they're listed as being for 2mm thick magnets. This leads to them not sliding down far enough over the screw top to lock in place against the locking ring.

Good print. Great fit and the supportless pulls are pleasing enough I stole them to remix onto some swing-out 1/3-spool drawers. I've already done 2 sets. I'd love to see some larger drawers in this style, as in 3 or 4 per spool. Also some kind of stops yo keep drawers from accidentally pulling all the way out.

Good profile. Easy print and fits well. I did go in the slicer and swap the knob first a small printed pull, but that's just for aesthetics, to match other drawers I already he'd. Also, I'm unclear why the bottom hole uses a cut connector.

Excellent profile. Solid print and exceptional fit. No worries about them falling out or needing glue.

Printed fine. Too large for Sunlu 250g spools.

Solid desgn and easy print. It's a little small, however, so if it's not an easy place to check it often, go for something bigger.

The slot sizes are weighted a little heavily to the tallest slot. I had to do some editing to balance the slot sizes so my shorter remotes would fit in smoothly and without rubbing, but that was easy enough, and I like the design.

Great fidget, solid profile!

I edited them to be slightly taller to give more rear surface, and stuck them on with 3M straps to avoid drilling. They hold my full-size SaberMaster sabers beautifully.