Search models, users, collections, and posts
Used some filament adhesive/glue and it worked and all (mostly) fit perfectly. Had to trim down some of the back mesh a bit (just used a pair of scissors since the filament layers were thin enough) so I'd be flush with the base, but other than that no issues
Share
0
0
0
Used super glue to keep the characters in there - works great - love it
Share
0
0
0
Currently using for a limited edition 3ds I own - love it!
Share
0
0
0
Add a paperclip on the bottom when the head is installed and its a fun fidget toy - love it
Share
0
0
0
I looked online for Joystick cap replacements for my "PowerA Wired Controller Plus - Super Mario - Nintendo Switch, Red" and all the ones I found were too small - they attached on fine, but the base of it was too small and I could see the PCB below. So I just made my own here. Not perfect, Could be improved upon, its a good starting point. Base curvature could be raised a bit higher on the base (or moved up) and the top of the stick could be remade to use rubber coating in theory
PowerA Switch ProController - Large Joystick
9
30
Share
0
0
0
No more data