Njdevil81420

tjbeck26

3d printed personal build of a floating shelf (hidden bracket) for corners. the generic size is scaled to fit the x1c buildplate in the most basic orientation. scale up or down as needed and feel free to expand on the model. I am working on a cleaner version now and will update later. Thank you.

floating corner shelf and mounting bracket

shelf

ByteSlinger

This is a replacement for the stock TPU gasket for the <a target="_blank" href="https://makerworld.com/en/models/19535#profileId-19420" rel="nofollow noopener">BLV AMS riser</a> by <a target="_blank" href="https://makerworld.com/en/u/4047283342" rel="nofollow noopener">BenLevi</a>, but with built in downward facing LED strip holders.&nbsp;The BLV riser itself does technically have LED slots in it, but they can only be used with certain types and sizes of LED strips, they have to be fitted when you&#39;re putting the riser together, and they are facing inwards rather than down at the print bed.&nbsp;This mod fits into the same place as the stock TPU gasket but features an extension that sticks out over the print area with a mount to hold LED lighting strip facing down (which also means you don&#39;t get glare from the LEDs facing up).&nbsp;Different Sizes There are 3 different sizes available, designed for different size LED strips.<ul><li>Thin: LED strips up to 5mm wide</li><li>Standard: LED strips up to 8mm wide</li><li>Large: LED strips up to 12mm wide</li></ul>Print Settings<ul><li>Material: TPU (I used Bambu TPU95A)</li><li>Infill: 15% Rectilinear (I usually prefer Gyroid but rectilinear works better here)</li><li>Walls: 3</li><li>Layer Height: 0.16mm</li><li>Supports: None</li></ul>Wiring The stock BLV AMS riser does in theory have a very small pass through hole at the bottom at the back for wires for LEDs, but it&#39;s far too small and not well positioned. I found the best thing to do is to carefully drill a 3.5mm hole (if you haven&#39;t already printed, you can just use a ‘<a target="_blank" href="https://www.youtube.com/watch?v=oJ5dqHZQ2p4" rel="nofollow noopener">negative volume</a>’ to add this into the print).&nbsp;You&#39;ll want 1m total of LED strips, split into two 50cm pieces. Wire them both to the power source at the middle meeting point.<figure class="image image_resized" style="width: 75%"><img src="https://makerworld.bblmw.com/makerworld/model/DSM00000000067465/design/7a91eb72-ac4b-4179-ac6d-662882dfac7d.jpg"></figure>Here is how I wired mine together, but in hindsight, if I was to do it again, I&#39;d line them up so they were basically touching and solder them directly to each other, that would be a lot better.

shelf

led riser