Nihilu2

Mdesign

Side spool holder. The other filament holders were very far back for me so I made the spool holder to be more in the front. To assemble the roller you need a bearing with a diameter of 22 mm and an internal dimension of 8 mm (bearing 608ZZ). To screw it together you need the original screws that come with the rear spool holder. I recommend putting double-sided tape on the part where the filament is held (but it's not necessary, holds on its own but to achieve the best result). Enjoy :)&nbsp;Edit: The first version had small tolerances between the main part and the PTFE tube holder, the tolerances were increased and the error corrected. Also the tolerance for the inner diameter of the bearing on the roller was changed. Edit: Based on the comment, a second version of the PTFE holder was made.

Side spool holder for P1S, X1C

m.cody.sims

Just a good Mando helmet!&nbsp;My profile doesn&#39;t have support on the inside of the helmet because I have found it didn&#39;t really help that much with the quality and it used a lot of filament. the very center of the inside will be rough because of this but it hasn&#39;t been an issue for me.&nbsp;For those wondering what I use for a face sheild I use a Hobart 770580 Face Shield Replacement Lens, Shaded from Amazon. I cut it to shape and use a little bit of hot glue along the front and near the temples. That seems to be enough. I would recommend getting air soft helmet padding for a custom fit and comfort.&nbsp;If you like my work, please consider supporting me by boosting my model or <a target="_blank" href="https://www.buymeacoffee.com/m.cody.sims" rel="nofollow noopener">buying me a coffee</a>!

P1

Cosplay