Sadly, it doesn't work with a 7th-gen NUC motherboard. The one I have has two "bumps" (for the WiFi chip and the SD card reader) that make it so it can't slide in.

Shame, since the case prints very well and in a short amount of time, and it feels relatively sturdy even without the motherboard to give it extra rigidity.

Nanianmichaels

Ziever

Intel NUC 8th gen complete case

0.12mm layer, 2 walls, 15% infill

Printed a couple, this is the one that didn't get used. Good model, easy print. I might be doing something wrong, because opening up the fins required a rubber mallet. I wish there was an easier way to bend the fins...

jrodbrown58

BC-250 Scooper

0.2mm layer, 4 walls, 15% infill

Absolutely amazing model, though it might have been one of the hardest ones I've ever printed (by no fault of the creator, that's on me).

I've printed two of these, one in black PETG and this one in matte blue PLA.

The PETG one printed just fine after I added ears to the base.

The blue one... well, something else altogether. Since I also wanted to add the texture, there were multiple failed prints from the head just yanking the whole thing out of the print bed while doing the texture at high speeds.

Finally managed to do it by making the print go at 50mm/s, which didn't increase the time it took that much, either.

The only suggestion I'd make is to maybe work a bit on the ring tolerances, as it is it's a bit of a tight squeeze. And superglue is highly recommended to fix the ring in place, as its original glue is... not great.

MakerVerse Designs

MagSafe Wallet - cards and cash

0.15mm layer, 2 walls, 6% infill

Very useful print, and the end result feels solid and sturdy, which was something that I was worried about before assembly, especially when considering the pins.
You'll need 12 containers total for one spool, so plan accordingly.
I've chosen to glue the stacker wheel to the bottom, it will make it easier to not have everything discombobulate itself when moving/separating the rolls.
Hole lids may need a bit of glue, too. Even though 7 out of the 8 press-fit correctly, one didn't, which is basically inevitable when you're dealing with cardboard.
I will point out that the profile is missing one pin on the second plate. You need 4 but only 3 are present.
Overall, very satisfied with the model. Thank you.

Brisolo

Overture Spool Storage Bins

0.2mm layer, 2 walls, 15% infill

Earn this badge when rate or comment more than 200 different models

Stellar Reviewer

Earn this badge when print successful more than 100 different models and 500 hours

Pioneer Maker

Earn this badge when visit MakerWorld more than 20 days in last 30days UTC time