didn’t change a thing. had to widen the holes for the chain a smidge with a jeweler’s drill bit by hand. printed in one color then painted with acrylic markers

I’m hoping to use this on my bridle. Printed perfectly. I used transparent filament for wings. The fully assembled photo is after I straightened the rod using a heat gun. I was able to remove from the build plate easily. I’d make sure the plate has completely cooled and begin by flexing the plate. I was a bit concerned about having the wings rip but they are tougher than they look.

adorable print. no issues

just what I needed for my old phone used in the barn for music. the holder’s a bit big but that means it could fit the larger Otterbox cases. Smaller phones sit properly thanks to the built in wedge at the bottom.

if I needed the entire tail I would be reaching for the glue. I’m new to printing and have only printed a handful of figures. But the supports seemed thicker and attached too aggressively, especially on the tail. the ones surrounding the ears were a little tough but broke away cleanly. regardless, this print is amazing. the detail is superb.

my first week of 3D printing I had an extruder jam. I sure wish I had printed this FIRST! removing the tubes was terrifying. Trying to push the ring, pull the tube and not strain the z axis (the videos show the top but not how they’re keeping the extruder steady)

a fun print but it doesn’t always return completely. I’d imagine it might frustrate someone looking for consistent repetition. I was hoping to use it for clicker training but the sound’s not quite sharp enough for my taste. I used SunLu PLA “elite”. thank you for generating this model.

⭐️⭐️⭐️⭐️⭐️Bambu won’t let me give a 5 star rating due to me canceling a print. I printed this model more than once and the results were quite good. I plan to paint the eyes and then cast in a resin globe as a gift. I scaled it a bit but the detail was still quite good. the supports were easy to remove.

printed well. quickly with no support or even skirt. no adhesion issues despite small area of plate contact. I printed in PLA as an experiment connecting 2” plastic chain.

cute design and prints quickly. perfect to keep around for gifts. Thank you for sharing