Came out great!

I haven't tested in this in PLA, but this contraption is oddly satisfying in TPU for AMS and also TPU95a.

Turned out nice.

printed great. strings are a bit weak but can be easily replaced with a light stick and string. voila.

Not too shabby!

Great way to test out new filaments. I printed this in Teqstone Transparent PETG. I'm pretty happy with the quartz-like results. The mechanism passes through very easily.

works great, the only improvement would be to have a cutout for center bottom phone chargers.

I'm honestly very impressed with how it turned out. I'll boost this for sure! I tried to make a pool-blue looking filament to use for it. Other than some unavoidable stepping when looking closely, I couldn't hardly ask for better. Any tips on removing the steps pre or post production?

Fun and beautifully simple!

The ammo is spectacular, they're stupidly simple but amazingly effective! I'm not even being sarcastic. This ammo is way more fun than bb's. However it would help a lot to have a 6mm wide 'stick' that's long enough to bore out the barrel slightly by ramming it in and out until the ammo will glide smoothly. It's those layer lines, they're what's causing all the friction.

Snaps together snuggly but without too much trouble. Starts off with a bit of excessive friction, but with a little elbow grease and silicone lube, it works great! This is also a great tool for introducing kids to the concepts of engineering, physics and geometry all in one. Especially if you explain it as you help them assemble it together. It's not recommended to let young kids play with this on their own though for two reasons...the pieces are a choking hazard, and the dirty goblins could leave pieces on the floor for you to step on just like legos or caltrops.

absolutely beautiful!

pretty nice even in PLA! I wonder what it would be like with that softer filament materia?l

Had to make do with the colors at hand, but I think it turned out far above my expectations! All that's different than the profile is red filament instead of latte.

I printed in PLA and it turned out better than expected! It's quite pretty, I need some translucent asap lol.

It printed perfectly!

Not too shabby, it does exactly what the sticker says. I'm gonna make my next one more colorful with multicolor filament.

will be fun to assemble.

Looks beautiful! now I just have to print the spinney bit.

simply amazing! thumb part printed goofy, but it still works wonderfully.