Wifey Points! Thx! Used Sunlu PLA. Rest of the earing pieces from Amazon (1 earing + 2 rings ea) Left settings alone aside from my calibrated filaments. H2D Printed beautiful. No clean-up.

Clean print. Structure popped of with index finger. Good Instructions. Great job. I'd increase bottom layer to 5 on the display to hide the black infill. Modified colors to represent the Laser.

Easy print. Not enough fidgets for Motor Heads. Thanks! 1-6-5-4-3-2-7-8 = Ford ;)

Printed beautiful. I snapped one of the pieces holding the axle cradle because I didn't clean the supports off good. Lazy ... I'll update the post when I use it. TPU is on the way. I had to do a couple min of sanding to get the underside pushed into the riser. This needs to be snug. So sanding it in is the way to go.

Had minor issue where print was working its way out at the different spool "nodes." I can't point at the config. It was -13F in MI that day and had to heat the chamber to print. Unfortunately the Creality chamber heater's lowest setting is 40C. I will usually heat to 35C and start the print and shut the heater off for PLA or PETG (the bed heater keeps it warm.) This print may have seen 40C the whole time. I sanded the few rough layers down. Axles were tight. I sanded the support side quite a bit to get the axles loosened up. Little cleanup. But very functional.

Good to go. Plate to Fan in about 5 min. Thank You.

Test printed these while I was waiting on the Olive filament to arrived. Cleaned up nice. Take your time clearing away the supports.

Nice print. Perfect fitment. Be careful! Those plates DON'T have doubles. They're mirrors. Ya, I did it. Don't!

Awesome print. Pulled off the plate, exercised the door, loaded and tested good. Beautiful to boot.

Great little valve. I had to reprint the flapper from twisting the neck off. With a little extra clean up in that area everything works fine. Use these every day on both the P1 & H2.

Everything printed well. Thank You!

Good Print. Clean. Thank You!

Good to go! No clean up. Easy fit.

Nice n sturdy! Have a couple pound power supply for the AMS Pro heaters. No flex!

Perfect Fit. Thank You!

Love em. Clean print. Very little clean up. Work perfectly.

Good to go. Love these things. Thank You!