These are a MUST HAVE for punch needling. I tried to learn with regular embroidery hoops, and they just couldn't stay tight enough. The ridges on the inside of this hoop really make a massive difference. My only complaint is the hole for the nut is a little big, so an m4 nut just twirls around in there and I needed pliers to tighten it.

Printed great and works just as described! Even the tiniest of jump rings stay in their container when it's shaken up.

Love these and they printed great! Wish I had maybe added variable layer height to the discs on the inside, the layers are pretty obvious, but it doesn't affect the function at all.

Printed perfect on my X1C!

Printed perfect on my X1C! I went for the double sleeved option. I don't double sleeve, but it leaves the perfect amount of room for tokens.

printed great and my kittens love it!

Print went great. Problem is, the 1" option is NOT 1". It appears to be 24-25mm, making it just under an inch, and impossible to fit a 1" dowel in. I had already purchased everything I needed to set this up and I am very disappointed.

Printed pretty much perfect in silk PLA on my X1C. Only issue was an adhesion issue on my side.

Printed great on my X1C!

Printed great on my X1C

Printed great on my X1C, love the thin walls!

Printed great on my X1C

Printed great on my X1C

Printed great on my X1C

Great print on my X1C, love the thin walls

Printed great on my X1C

Great print on my X1C, love how thin the walls are for clean cuts!

Printed perfect in my X1C!