Search models, users, collections, and posts
Bio
I am a young 3D design and printing enthusiast. I create unique models as often as I can, and I hope you like them.
All my filament and parts come from gift cards, so please boost me to help me continue my interest in 3d designing and printing.
I greatly appreciate every print/download/boost.
Thank you for reading this, and once again, I am trying not to beg, but I would appreciate it if you check out my models!
Achievements
MakerWorld Guardian
Active more than 20 days out of last 30 days UTC time
Pioneer Maker
Print successful 119 different models and 764 hours
Share
0
0
0
What project should I work on next? Comment below!
Share
1
4
0
Check out my new puzzle! It is small and compact, and use it to kill your boredom. IT can also be used to help you look away from screens!
The Classic 12 Piece Barrel Puzzle Brain Teaser
1
1
Share
0
0
0
Check out this new puzzle!
The Classic 12 Piece Barrel Puzzle Brain Teaser
1
1
Share
0
0
0
New model! No matter which angle you hit the ball, if you hit it at the right speed, it will always be a hole in one!
Share
0
3
0
Check out this mini golf course! No matter which direction you hit the ball, it always ends up in the hole!
GIF
One And Done! A Mini Golf Course
2
3
Share
0
0
0
Anyone want to test out my model? It would be really helpful if anyone could give me feedback!
The model is no longer public
Share
1
3
0
Looking for a new project? Check this out! Please print it and test it out for me! I am happy to take any suggestions!
The model is no longer public
Share
0
0
0
The post is no longer available
Did you forget to get your a mother a gift for mother's day? It is only a week away!
Last Minute Mother's Day Gift Joke
34
46
Share
0
0
0
does anyone have a drawing or dimensions for the servo horns that come with the 9 gram servo
Share
2
4
0
Share
1
0
0
Need a way to hold your Pickleballs? Check this out!
Pickleball Ball Holder
13
45
Share
1
1
0
Share
0
0
0
Share
0
2
0
Share
0
0
0
Share
0
3
0
HELP!
I just replaced my printer's nozzle, but it has had spaghetti one EVERY print!
I looked closely, and found out that it was caused by warping, and low adhesion. I have cleaned the bed, swapped the bed, cleaned the microledar, swapped the nozzle (fro 0.4 to 0.6), and nothing worked.
What could be the culprit?
Share
0
0
0
I just replaced my printer's nozzle, but it has had spaghetti one EVERY print!
I looked closely, and found out that it was caused by warping, and low adhesion. I have cleaned the bed, swapped the bed, cleaned the microledar, swapped the nozzle (fro 0.4 to 0.6), and nothing worked.
What could be the culprit?
Share
1
8
1