I was just browsing from the phone app and printed this on a whim. I was pleasantly surprised to see the surface designs not only on the top side but also on the plate side. Excellent print file in PLA. Saving this so I can print again in the future.

Simple but perfect. This worked great on my 10m dipole. Printing another with scaled diameter of 200% to test on other bands. Would love to see one this diameter with 15 twists for 40m.

Thank you for including supports in the file. Printed perfectly from the app.

Don’t print directly from the phone app. The last inch of printing went terribly wrong and the threaded section was all buggered up. I printed again from the desktop program and it went fine. Was not a drying or filament issue. Wasn’t settings either because it was the designer’s print profiles both times. Otherwise a good project.

The look perfect. Thanks

Fit well. Great print.

Girlfriend loved them. Used a heat gun to soften, and cold water to instantly set the shapes.

Good design.

Front is a perfect print. Used the extended back and the sides fit together very well.

Good width but length is a little short. I'm going to print again after stretching this closer to square shaped.

Worked great!

Hinges printed out perfectly. Very happy with the print.

Print came out great. Fitment was perfect.

Perfect size to fit 4 one an A1 plate. Print came out great.

Printed great! Fit well and feels secure enough to EDC.

Print looks great. Very difficult to get the water level and/or angle just right but when it works it's great!

Printed both versions. They are both great!

Looks great.