Search models, users, collections, and posts
Bio
Hi everyone! I got my first 3D printer (Elegoo Neptune X) for my 11th birthday. Ever since then, I got more and more into designing models and printing.
I recently got a printer from Bambu Lab (A1 Combo), and I love it! I actually completely switched to MakerWorld as a result (mainly for the points 🫠)
If you have any questions, please message me!
Achievements
MakerWorld Guardian
Active more than 20 days out of last 30 days UTC time
Pioneer Maker
Print successful 146 different models and 668 hours
Printed well, but unfortunately didn't fit my Xacto knife
Share
0
0
0
I just designed this model 4 times to get the perfect fit! This "spool indicator" just snaps on to Bambu spools to let you know you need to dry it!
After leaving my filament in the garage for a while, I needed to dry EVERYTHING. I initially used some pieces of tape, but that wouldn't cut it.
Please check out this model and consider printing a few! Thanks
#Newmodel(Edited)
Share
0
0
0
Do you print or buy your spools?
Do you print or buy your spools?
74%
Buy
26%
Print
34 votes
Final results
Share
0
8
0
Share
0
0
0
I made this bucket for the Polestar 3's really deep armrest compartment! Check it out:
Customizable Polestar 3 Armrest Bucket
16
50
Share
0
0
0
I made a armrest bucket for the Polestar 3! Check it out!
Customizable Polestar 3 Armrest Bucket
16
50
Share
0
0
0
Great model! I didn’t read the discription, so the fittings I have didn’t fit. This is NOT the designers fault!
Share
0
0
0
I made an innovative funnel printed in VASE MODE!
Please check it out!
Vase mode funnel (scalable)
1
1
Share
0
0
0
I made a vase mode funnel that only costs 10 cents and uses just 4 grams of filament! Check it out!
Vase mode funnel (scalable)
1
1
Share
0
0
0
Great print! I printed 16 pieces (12 middle pieces)! I also put on some rubber feet.
The tolerances were a bit tight, but overall great print!
Share
0
0
0
Good print! The plug doesn’t fit, but that’s not your fault!
If anyone’s wondering: the hole is ≈44.5 mm big.
If the designer could make a bigger version, that’d be great! You could also send me the F3D files and I’ll make the tolerances bigger and share the profile!
But overall great print; the fit error isn’t your fault!
Share
0
0
0
I needed a spot for my glue sticks, so I made a Gridfinity module for them! Check it out:
30mm Gridfinity glue stick holder 3 pack
7
32
Share
0
0
0
I was disappointed with fridge magnets, so I created this model that works with a 3x6mm magnet!
(ask me to make a different size!)
Simple Fridge Magnet
5
12
Share
0
0
0
No more data