Search models, users, collections, and posts
Achievements
MakerWorld Guardian
This badge has expired
This was a very early model that I made of a gingerbread house. I wanted to print it flat with no supports and I wanted to be able to just do color swaps. It is far from perfect, actually it's a slight bit crooked but it's adorable and it's super light and I'm still a little proud of it =)
Flat pack gingerbread house
4
8
Share
0
0
0
Fallout 76 Vault dog house from Season 22 Modern Living. I loved the look of it and decided I wanted to model it and this is it. This would be the clean pre apocalyptic version. At some point I might dirty it up and give it some texture. But of course you can do that with paint.
Vault Dog House (Fallout 76)
9
39
Share
0
0
0
Share
0
0
0
I was digging through my closet and found my oversized shirt with this logo on it. As the shirt is not getting any younger, I decided that I wanted it in a more durable medium.
Driving Pleasure Fahrvergnugen
3
1
Share
0
0
0
For those using the print profile: if you change the Quality settings 'order of walls' from inner/outer to outer/inner there shouldn't be the lines on the outside where the walls are seen.
I use the print profile and the box that was printed was too small (for my Altoids box), but I should have checked that before I printed it.
Share
0
0
0
Share
0
0
0
That's an easy print. With well-tuned filament it fits together very nicely. The only drawback would be the hook ring, if it gets bent it will break.
Share
0
0
0
Simple model simple print. Perfectly fine. I did make mine thinner, but I realized that that's a mistake because then you have less concentration of glow-in-the-dark particles. So, by making them thinner I actually made them dimmer.
Share
0
0
0
No more data