Love this model. Combines Lego and 3D printing. Arm and Leg joints are a little loose for me. I’m going to try tape as the designer suggests.

Prints perfectly. The only issue that I had was at the front edge where the supports connect to the top of the Hygrometer hole, the support structure was slightly fused to the model. Just a little clean up needed but nothing too bad. Design wise I think that if the lid for the desiccant area would slide into place would be an improvement. Currently at the back or the model there isn’t much supporting the desiccant lid so it seems loose or flimsy.

I had no issues with this print. I do like how there was numerous options available and just needed to select the one I needed.

I only had very minor issues the did not effect function of the print. On 2 or 3 there was some lines of stray filament on the inside of the treaded part of the container side. However once I snipped them off it was completely functional.

The model itself is awesome. The problem is that the support that it printed with is not sufficient enough. I had it fail twice in approximately 60% complete. The support under Zero’s left ear would break and fall over. I changed the support structures to have 2 wall loops and it printed without any issues.

I had no issues with printing this fidget spinner. It turned out very nice. It rotates/spins so smoothly.

I had no issues printing this desiccant box. very clean design and the lid fits great.

I had no issues with printing this poop bin. The only problem with this bin is it still allows the poops to build up and clog the poop chute. In other words on an 6-8 hour print still check to ensure the poop pile isn’t building up in the bin.

This flexi Orca Whale printed so smooth. The attention to detail and real to life features are so awesome. Love it!!!