made my wife happy

fun cool little creature

It took a lot of tries but I finally got Gandalf and his side complete. In resin on Saturn 4U. Two FDM Gandalfs in the back.

I have long had an issue with students messing with the water at lab stations. Problem fixed.

I sliced the bottom for one of these so it printed on the plate better then took a slice and glued it to the first one. hope that makes sense.

This worked for my Biqu liquid glue too

The middle wall was really difficult to assemble, I had to use a needle file to team out the slots. I also adjusted the size of the brackets because they were too tight. otherwise it’s very cool. In hindsight I’d forego the center wall and just make two cubes if I did it again.

I use 03 size filters and this works great.

great

I have a top mounted AMS lite with z-axis stiffeners and this worked a charm.

I wish there was an option to just use screws instead of filament for the hinges.

I’m a physics teacher so I let one of my chem colleagues borrow this for his class.

wobbles a bit

same issue. couldn’t stand having one missing.

printed the pads in tpu. works great

kinda loose.

I had to break off two of the ridges holding in the puck light so I could remove the light and change the batteries. still works.