Lurchi666

Preischl 3D

Do you like my designs? I would be happy if you would support me by joining my Printables club! :) (already from 3$) It also gives you access to exclusive models ;) https://www.printables.com/@Preischl3D Or do you want a sales licence? Then you can book the commercial tier!&nbsp;All models I publish are tested by me and my community before I publish them.Here you get a small but very practical d6 dice box tower that has been designed so that you can insert round 5x5mm magnets. This gives a secure hold of the lid for transport and looks super sexy.It is intended for small D6 with max. 1.25cm edge length

Round D6 Dice Box Tower With Magnets

Kathy GB

J3DPS

One of my first Hueforge projects. A simple skull with a rose.&nbsp;Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmFilaments Used:     PLA+ Sunlu Black Transmission Distance: 0.6     PLA BambuLab Basic BambuLab Green Transmission Distance: 8     PLA+ Sunlu White Transmission Distance: 5Swap Instructions:     Start with Black     At layer #8 (0.72mm) swap to BambuLab Green     At layer #12 (1.04mm) swap to White for the rest.

Hueforge Skull with Rose

Balzo98

Here for you Warawara! I loved Warawara from the first time I saw them! On my profile you can find some other warawara and Studi Ghibli model!Hope you enjoy!

Warawara

Kunsdt

MottN.

Update 6/25/24: Updated geometry to be a more secure fit and  also fit A1 Mini (big thanks to Aleks89 for feedback and testing on the Mini). &nbsp;After the 3rd time my cable snagged on the upper frame, I decided to make a quick cable guide. I&#39;m not sure why this wasn&#39;t included in the printer design as it seems like it would be a common issue even with the recommended AMS locations.&nbsp;There are lots of ways you could achieve this, mine rides on the z axis and holds the end of the cable far enough in it doesn&#39;t snag on the corner of the frame.&nbsp;It should snap into place with a little effort.