Other Issues:in theory this is good but it doesn’t fit standard sized wet wipes. Also, the lid handle doesn’t make sense. Is it meant to click into the top of the box or not? becuase if it is meant to, the handle falls off every time you use it and then what would be the point of the magnets? And, the supports for the magnet on the inside further shorten the room on the inside to fit the wipes. I’m in Australia and wonder if we have different sized wipes but I’m guessing they all come from the same place. had to slice about 50mm off a pack of wipes to get them in there. this model has so much potential but for now I can’t give you the stars. it feels like a huge waste of filament sadly.

Other Issues:overall, I like the model, I like its potential. but there’s some issues. 1. the flow rate regulator is near impossible to attach. maybe there’s a way to remodel to have it print in place or make it easier to connect, as there’s a lot of room to fit it under the lid. 2. I’ve printed 3. it works on only one type of bottle that I’ve found but even then the consistency of the ability for it to screw in without leakage is not good. I’ve printed many caps that perfectly fit multiple bottles. I think you’d have a winner if you can make it to fit Coca-Cola - style bottles, instead of single use cheap water bottles. I like the potential but for now it’s not effective and I’ve moved on to seek alternatives. but I encourage you to keep refining it as the model shape and size is perfect if not for some tweaking.