still too thick for my door I wanted to use on. works great otherwise on the right door. bit of flex holding up a backpack

came out great

pills get stuck in the cone crevice. The perhaps make the inside more rounded vs a sharp cone

awesome. printed 8. paired with 3d printed bearings. planning to use these for small scale testing/orienration before investing in metal ones

works well. some outlets need longer screws. would be nice to have an reverse option where the block is on the left side if it’s mounted on the top of the outlet

printed ok with support. also scaled to 120

middle hole is 1-2mm too small. outside edges are fine and fit well with non-3d printed pieces

scaled to 120%. had to cut the back board to fit. also added a earring holder

love the flat option. the finger hole could be better with some texture to it. or even the outer edges

box fits very snug. printed 2 sets of links and increased size of box

works well.

snug fit. had to take out spools and insert at weird angle with some force to fit

it’s ok.

lose fit

loose fit

fit together well. wish they were taller (deeper drawers)

great fit