Search models, users, collections, and posts
Bio
I have an A1 mini :O Although I have been 3d printing for 5 or 6 years, I still am quite the amatuer 3d designer and new to bambu software. I am looking to save up in points and gather together some money to buy myself a lithopane bundle for lithopane prints! Anything you can do to support is greatly appretiated.
guys, i disconnected my ribbon wire on my a1 mini, it was an accident, i was tryna get pfte tubs out cuz they were in my way when i was opening up the extruder, now i got most of the extruder back together, but my filament sensor ribbon wire isntt connected... any suggestions?
Share
1
4
0
Guys imm tryna make a lithophane... Not going well. Swapped to the 0.2mm nozzle, and kept the textured pei plate. I tried to offset the z, and it hasnt been effective. I also played with temperature of build plate, and a lil with nozzle temp too... What do I do?
Share
1
31
0
Make some fancy maracas that spread through joy through sound and fashion. Put extra filament waste (poops) to use in these maracas and enjoy the vast world of tunes you can create!
Mushroom Maraca
14
28
Share
0
0
0
No more data