Liquid

TripleGWorkshop

Made this to give the extruder a better angle for the PTFE tube on top.

Bambu X1C Tall Top Glass Spacer-Slider

riser for top

Robert ONeill

Mounts to the side and back of a Banbu x1 carbon printer. redirects the purge waist to the side. Into a removable bin.&nbsp;It has holes to mount a set of magnets that hold the removable bin in place.&nbsp;There are hole to mount with the screws around the poop shoot. I have found it better to mount with double sided tape. not using the holes. the screws are self tapping. these are problematic to put new screws.&nbsp;Two of the parts are meant to be glued together. Minimizing the support material needed. the part can be printed with minimal support.&nbsp;The edge rail help the filament not get stuck. If you open the STL the default orientation is not optimal.The design orientation is shown in the 3mf file.&nbsp;There are edge rim thickening to save on material but keep strong.&nbsp;The metal piece that came with the printer is intended to be mounted on the side. using the default screws and M3 nut pressed into the print. The print helps distribute the load. This extension will need support.&nbsp;A filament Y that goes around the corner is:https://makerworld.com/en/models/170250&nbsp;The magnets are 6mm dia and glued in. I used it for a long time without installing the magnets. But once installed bin homes nicely.

purge bucket, side mount, removeable poop chute, with side filament 

Poop Chute

bonfiggy

Perfect fitting antivibration feet printed in TPU with 15-20% infill for best results. No supports needed! Seems to help a good bit as well with the shaking/noise and a lot less printer wobble as well :)

riser for top

Poop Chute

Anti vibration feet