Wow, next level support removal. I think I spent more time removing supports than printing :-). Fantastic job modeling this. Printed in a Bambu Marble PLA

Excellent design and clean print. I had some ABS-GF that I had purchased for a project that fell through so perfect place to use it. I had a flipper and mounted one on the top of the machine but really missed being able to look through the top easily.

I cut a book for the swatches to be stored in. Still need some sanding work on the cover.

Holds a lot of pens.

Great way to give a gift card.

I resized it to hold a few more pens. Great build

Printed this for my wife for her birthday

Printed this for my wife for her birthday

Really liked how this turned out. I had to get the magnets but these pictures are right after printing.

Printed great and fit just right.

Excellent build. I printed at 40%. Next time I will have to paint some supports for the eye slot but that is on my slicer not putting them in.

I printed this at 200%. It turned out fantastic

Fallout is a great franchise. This printed out very nicely

Great way to access the top of the printer without trying to figure out how to safely remove the AMS. Fit great and only needed the bolts listed.

Nice print. Thank you

Excellent upgrade for the conveyor system on the S1

They work as advertised. They stack well and the cups dry on there much faster

Excellent PIP design. Thank you, the latch works well in my case. I had seen a post about it not working for someone. If you are concerned or it doesn't you could add a couple of mm's to the Y axis to put more pressure on the latch button. I will be making a couple more of these.

I added a little to the Z axis to 2.5 mm just to make sure it had a bit more strength. Beautifully done and printed out perfectly.