Search models, users, collections, and posts
Bio
When you need to type something but type nothing
Achievements
MakerWorld Guardian
Active more than 20 days out of last 30 days UTC time
Stellar Reviewer
Rate or Comment 432 different models
Pioneer Maker
Print successful 377 different models and 2,481 hours
Beautiful design but the lid wasn't supported when printed through Bambu Handy and it was just a mess of filament inside the very top. As this is being used as a wedding gift I needed to reprint. When I downloaded it into Bambu Studio to add supports, I could see that supports were enabled but the "Threshold angle" was set to 10. So it wasn't generating any support in that area. For anyone else with the same issue............
Share
0
0
0
No more data