works good, you need to push the buttons a few times to make it easier but I like it!

this is soooo cool I love it! looks good, printed good and works good!

looks good! I don’t think it should have ears though

looks good! I printed with glow in the dark PLA, I also changed the infil from 40 to 20 so it saved time and filament. it’s bigger then the real one but if you sized it down a little it would be good. I’m not sure if it’s because the real one I was holding is the rose p365 but I’m also pretty sure I was holding the 380 ammo one and not the 9mm, and to my understanding the XL is the 9mm one and in the rose one the 380 and the 9mm are roughly the same size. So if you know, is the “rose” XL one smaller then the normal p365 XL?

printed good I printed at 50z speed so it would be better quality, still messed up a little, it’s pretty hard to squish, I did the circle one

printed good, I decided not to put on my mini surron but it looks real, I fell like the fender is a tad bit small

fun it’s a little firmer then I thought but I might try in TPU I printed in PLA

love this!!! highly recommend printing for your a1!!

works good and satisfying, it’s loud

printed good and fun to play with, no need for glue either! just snaps right together

works good and it squishes

works good! I had the right size of magnets but they were to tall so I had to use these small ones, they work but are really loud because they move around

printed good other then the end, not sure what happened. happened right after the pause (seen in pics) cleaned up fine though!

fits perfect

pretty fast print and fits my door perfect

good! I already had the surron frame I just needed the screen from eride pro and the motor with the cover! I made a mini one to match my real eride pro!

works good

it works good, I’ve already printed about 5 things with it on and i don’t think there’s any problems with the cable. the cable used to hit my wall (shown in pics) but now it doesn’t!

looks good!

looks good and fits good!