Legomaniac

ZUPA 3D

Lego Busters Light Box&nbsp;ATTENTION: Remove purge line at the beginning of the print!&nbsp;You can use the 22mm rubber caps you can buy on aliexpress, for example, to give the LED wires a better finish.

Lego Busters Light Box

Lightboxes

The Crafty Maker

"We're doomed. There will be no escape for the princess this time .... What's that?!?" - C3PO&nbsp;The Star Wars shadow box saga continues. This time I bring you the epic opening scene from the Original Trilogy movie A New Hope or the ending scene of Rogue One - A Star Wars Story. It depicts Darth Vader boarding the Tantive IV in pursuit of Princess Leia.&nbsp;I've used the following colors:<ul><li>Plate 1: Geeetech PLA Black</li><li>Plate 2: - Geeetech PLA Black - at layer #3 - 0.6mm swap to Geeetech PLA White</li><li>Plate 3: - Geeetech PLA Black - at layer #3 - 0.6mm swap to Geeetech PLA White - at layer #6 - 1.2mm swap to Fillamentum ExtraFill PLA Signal Red</li><li>Plate 4: - Geeetech PLA Black - at layer #4 - 0.8mm swap to Fillamentum ExtraFill PLA Signal Red - at layer #6 - 1.2mm swap to Fillamentum ExtraFill PLA Traffic Red</li><li>Plate 5: - Geeetech PLA Black - at layer #3 - 0.6mm swap to Geeetech PLA White - at layer #6 - 1.2mm swap to Fillamentum ExtraFill PLA Signal Red</li><li>Logo: Geeetech PLA Black + Geeetech PLA White (multicolor)</li></ul>The colors are just guidelines, you can get creative with the color scheme for a personal touch.&nbsp;It consists of 5 numbered plates.&nbsp;I've also added a Star Wars logo that you can attach to the shadow box.&nbsp;You can find the box to display this set here: <a target="_blank" href="https://makerworld.com/en/models/13471" rel="nofollow noopener">https://makerworld.com/en/models/13471</a>&nbsp;The box with lid and the wall mountable box are both Patreon/Printables/Thangs subscriber exclusives. (Box with lid also available for individual purchase on <a target="_blank" href="https://cults3d.com/en/3d-model/art/shadow-box-with-lid-thecraftymaker" rel="nofollow noopener">Cults3D</a>)&nbsp;Print settings&nbsp;Plates<ul><li>No supports</li><li>100% infill</li><li>Arachne wall generator recommended</li></ul>Logo<ul><li>Basic supports with top Z distance of 0.24</li><li>100% infill</li><li>Arachne wall generator recommended</li></ul>ALL The Crafty Maker designs are protected by Copyright Law. By downloading, YOU HAVE NO RIGHT to sell any digital files or reproductions from those files. If you want a commercial license to LEGALLY SELL 3D prints, you'll need a <a target="_blank" href="https://patreon.com/TheCraftyMaker" rel="nofollow noopener">The Crafty Seller Patreon</a> subscription.

Lightboxes

Shadowboxes