nice now my kid can flex his tcg card

fun print for my nieces but printers beware its alittle bigger than expected to be a wand. so minor scaling down may be needed on the bambu studios

the last knuckle on both arms where its bigger, broke after a while. mayb a little tweaking to make it bigger and thicker couldve prevent that

wish there was a Bambu a1 mini version with clean cuts and connections

great design, I felt like in robot mode, it was too top heavy. had issues standing up without falling over if poses weren't proportional

great design, made 2 of these for my little guys

alittle bulkier than I expected but easier to assemble than it look

Made this in some extra translucent filament I had laying around, turned out better than I expected

loved it, had to print 2 of these since my little guys enjoyed so much. only issue was having to go look for the screws

came out wonderful, had to make 2 of them for my little guys...my little guys prefer the translucent filament with these low poly figures with the way they look