A little too flimsy. It feels like it's going to break between your fingers when you lifte it while empty so how does that feel when you have it filled with pens?

It will not stay spinning with squeezing the handle. It stops and/or goes in the opposite direction if you time it just a split second wrong and eventually something will break because of the sudden changes

good for a little while but then it folds the first few print lines off the tip and goes blunt. It's kind of hard to use afterwards.

Perfect

Too big for both sides, made my print fail

They stay in place and hold their shape very well and for a long time. And they easily get under prints that are stuck to the bed

too big for both sides of the spool, made my print fail

Good print that withstand use for quite a while

Good print, it spins for quite some time when you get it going right. I had some problems with the supports leaving chunks stuck on the "blades" and it made it unstable and not spinning for so long, So I had to do quite a bit of post processing work to remove that and get it spinning.

Great toy, the cat loves it so much that I printed more both for her and for friends cats. I do have a problem with the supports though. they stick and leave a mess at the bottom. It seems like the print is sagging around the supports too. Not sure what is happening. I have printed the old one, the old one with messed up supports and the new one. They all have this problem in various degree.

Great toy, the cat loves it so much that I printed more both for her and for friends cats. I do have a problem with the supports though. they stick and leave a mess at the bottom. It seems like the print is sagging around the supports too. Not sure what is happening.

Good print that does what is described. The only thing I have a problem with is that the supports stick to it like glue and tears out filament from the print. Lots of post processing to get it looking and feeling ok.

Beautiful print that really moves. Except for one link in there that got stuck on both normal and bigger size. the third to last joint fused together on both prints. Printed in dual color PLA. I had a tiny bit of stringing on the little one, but that is a setting issue on my side.

Very good print. Just perfect amount of ridgelines that gives the smallest amount of feedback to your fingers

I love this ring to fiddle with. The only drawback I found after printing a few of them is that some of them will stick during print. This causes a little deformation of some of the cogs. This again leads to a slower ring that still sticks a lille but is still usable

Great print and I like that I don't have to fiddle with buttons or clamps to hold the phone. The only negative thing for me is that I have to keep tightening the screw on the back so it won't tip forward. Printed in black PLA (I will print in ASA later)