Printed okay. It would be nice if the two parts could separate quickly for travel. Maybe notch the one set of privet holes.

Can you make a set with a longer threaded screw and bigger top for the shaft? It’s just grabbing the bottom thread or two and it’s hard to grab the protective cap when in a tube type case.

Works. Little tricky getting the sandpaper the right size. Cut it prior to taping it down it’s easier to make it clean.

It works fine. A little tricky to open without nails but that good when using a soft pool cue case.

Unfortunately the two magnets I have in that size aren’t quite strong enough. I had the chalk fall off and didn’t notice until another patron picked it up and returned it to me.

Thought it was two piece for portability but it’s just one. Works fine but it’s going to end up broken going back and forth from the pool hall. I don’t have a PC to make changes just an old iPhone I can use to print existing projects.

Clean lines and prints well. The two parts even able to go together. I’ll store them this way as a protector.

Strong and well thought out, even has over cut slots for easier cuts.

Printed fine but doesn’t work on my Dufferin or Crical cues.

Printed a second one that was customized. Looks great! 🍻☯️

Printed fine but haven’t tested yet.

Printed fine but haven’t tested yet.

Worked for one 2x4 case with independent tubes but my 2x4 Crical case seems to have just one internal nylon sock with 6 holes to put the cue halves in. So double check if you actually have tubes by putting in a goofball or other small item you can get out by turning upside down that won’t get stuck.

Seems strong enough and goes together well. Haven’t needed it yet but did test it. Might need to sand a few spots. Fits in a Crical middle pocket perfectly too.