Kleines_knuddelbaerchen

christiansotelo2244

A modular hydroponic tower garden made by <a target="_blank" href="https://www.thingiverse.com/boundarycondition" rel="nofollow noopener">boundarycondition</a> on thingsverse!

Modular Hydroponic Tower Garden

Pflanzen

Smart3d by Gabriel Gomes

Csgo headset stand

Computer

tdub55

stackable trays that holds sewing bobbins. Each tray is 156mm x 100mm x 35mm. (6" x 4" x 1 3/8") and holds 36 bobbins. I printed it at 15% infill with a .2mm layer height.

Stackable Bobbin Holder

Corinna

lindnjoe

Warning!! This takes patience to put together. Round Christmas Lantern with 3 thin layers that fit into a base. The layers have tabs on the bottom that fit into the slits on the base. The front layer “Merry Christmas” is printed in two parts, you will need to put those two layers together to make one. The layers are printed very thin at 0.2mm. Be careful when taking them off the heat bed. Slide the tabs on the end into the slits on the opposite end.You can size up or down. For best results size up.&nbsp;3 Layers to print and 1 base. &nbsp;A tea light will sit in the middle. You need patience when putting this together.

Merry Christmas Round Lantern

Weihnachten