Printed without problems. Thanks for the file 😊👍🏻

If you're having trouble with your A1 knocking down the supports towards the end of the print, print it upside down. Just make sure you don'live anywhere near trees because you will want to punch the s*** out of everyone of those f****** ;) This is my fourth try and it finally worked. Little rough at the top but hey it's a skeleton. Thanks for the model, I'm sure the Skeleton will make a nice gift.

turned out great, thanks👍🏻

Just what I needed, thanks. I attached the mounts with double sided tape to the Skadis bord and then pressed it against the desk. Just make sure you get the alignment right, can't get it off now 😂

printed them in both PETG-CF (the two on top) and Basic PLA. printed flawlessly with either Material, though PETG turned out nicer on the back plate. Thanks for the file 🤘🏻

Nice Design, the Level of Detail surprised me. Thanks 👍🏻