King Cel

FunkyArt

<div><h1>Summary</h1><div><p>Don't waste your last meters of Filament, print your very own cable ties :) . This thing was created for the last meter contest on Printables. The cable ties are surprisingly stable and also flexible enough when printed with PLA, but you should switch to PETG or TPU if you want to put heavier load on them. The last meter is enough for exactly 3 pieces. </p></div><h1>Print Settings</h1><p class="detail-setting rafts"><strong>Rafts: </strong>                         </p><div><p>No</p></div>                                    <pre><code>                                            <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></code></pre><p></p></div>

Cable ties - Kabelbinder 

Stuff

Kampflafer

<p>BOM is the Same as the original, aside from the 8 magnets I used to hold the basket in place when rotating. (Fits my 18g ridgeless VST basket nicely)</p><p>I used blind holes on my design to give the upper part a cleaner look.</p><p>The use of a blind hole tap is advised to start ¾ of the thread length, otherwise the part may crack when screwing the M3 Screw in an undersized hole.</p><p>BOM:</p><ul><li>16x  Magnets 5x2.5mm (2 stacked on top in each hole) </li><li>1x  M3x20mm SHCS</li><li>5x  M3x12 SHCS</li><li>2x  61813 ZZ / 2Z (65x85x10 mm)</li><li>10x  MR63ZZ (3x6x2.5mm)</li><li>10x  Acupuncture needle</li></ul>

Stuff

Coffee