Made a small safety lock clip for my French cleat tool wall. It slides in from the side and helps prevent mounted holders from being accidentally lifted off the cleat. I also added a small friction bump so it stays in place better, while still being easy to remove when needed. Not a load-bearing part. The cleat and wall screws still carry the weight. Printed in PLA, no supports needed.

I made this junction box cover to clean up the ceiling in my garage after removing an old fluorescent light fixture. After switching to a T5 light, the old fixture left a large exposed hole that did not look very good. This cover hides the opening, while a small notch lets the wire pass through to the new light. OD is 120 mm, height is 8 mm, and screw hole spacing is about 69 mm. Make sure your hole is smaller than 120 mm or it may not be fully covered.

A simple adapter for connecting a Cen-Tec style hose or fitting to the SawStop CTS dust port. Designed for a secure fit and easy installation. Enable supports and use a brim when printing.

A simple adapter that converts a Cen-Tec fitting to a standard 2” vacuum nozzle. Designed for a secure fit and practical everyday use. Enable supports and use a brim when printing for better results.

I recently installed two drainage pipes in my backyard garden but didn’t have any suitable covers. Ordering a ready-made one would take a couple of days, so I searched for printable designs online. After a long search, I still couldn’t find anything that matched my pipe size—so I designed this custom drain cover myself.

I used this model to mount my own kitchen pendant light, and the result was absolutely perfect—solid, centered, and extremely secure.