Here is my Angry Shark Clip &amp; Fidget Toy 🦈. Whilst it has a functional jaw which can be used as a clip to seal small packets with it&#39;s teeth, it will most probably be used as a fidget toy.&nbsp;Prints seen in the pictures were printed on a Textured PEI Plate, Esun PLA+ was used as my filament and colours seen in the pictures are: Silver, Black, Marble, Magenta, Orange, Gold, Light Blue, Light Green and Very Peri.&nbsp;I can&#39;t wait to see your prints so feel free to share them in the comments section!&nbsp;Please note, this clip/fidget toy is for ADULTS only as some corners along the tail and fin are on the sharper side and may not be suitable for children.&nbsp;Unless you have my explicit written consent, one does not have the rights to sell this digital file or printed models of my design.

Angry Shark Clip & Fidget Toy

Clips

Fidget Toy

This is a remix of phyXoo&#39;s Pokemon Gengar, it is a less see through voronoi version of the file. It is a great 3D print for a desk figurine or something to put on a shelf as part of a room&#39;s decoration.&nbsp;Dimensions of the figurine in photos66mm x 59mm x 69mm&nbsp;Filament UsedeSun PLA+ Purple&nbsp;

Clips

Fidget Toy

Pokemon

Vornoi