Check out this DIY Batman LED light for your wall!

This is a new multimeter mount for the popular Ikea skadis pegboard!

This is my custom F1 Steering wheel for my sim racing rig! full 3d printed (except electronics or screws ofc) and easily customizable for your needs.

V2 of my skadis hand vacuum mount

My second version of wire stripper mounts for the ikea skadis pegboard is now out!

Hey Guys, here is the second and optimized version of my screwdriver mounts for the IKEA Pegboard!

Ever needed a minimalistic cable organizer for your IKEA Desk?

Do you need a small bin for your 1S LiPos? This gridfinity-compatible bin holds 15 batteries and is very quick to print, no supports and about 20g of filament!

Ever needed a organiser for you hot air rework station? All the Attachments just lay on top, without any danger of them getting lost! Fast to print and less than 4g of filament needed!

Shifter Knob for the popular USB Shifter from Amazon or Aliexpress. No Supports, 20g of filament and less than 1 hour print time!

This is a small and very fast to print organiser for the different heads for the mini vacuum. No Supports under 20 Minutes under 5g of filament reliable and good looking

Skadis Hand Vacuum mount

its a small M3 Screw Spacer with a lenght of 10mm

This is a 45 Degree angled Hook, for the IKEA Skadis Pegboard. It is fast to print in about 40 minutes, has no need for supports and as show in the pictures, it is a perfect fit for my Toyota Supra MK4 model car. If you like the Model, please leave your printer profile! Printer: Sovol SV06 Filament: PLA, about 8g Infill: 10% seems sturdy enough Print Time: about 45 minutes for 1 hook

Skadis Wire Stripper Mount (Holex)(Ikea Pegboard)

Skadis Screwdriver Mount (Wera) for Ikea Pegboard Hello Everybody, I have designed 3 different sizes of screwdriver mounts for my skadis pegboard. You can use these with any screwdriver, as long as their shaft is not too big for the hole in the center. I have mounted my Wera VDE insulated screwdrivers, for which you need 1 large, 3 medium and 2 small mounts. They dont need much infill and have very little support structures. Happy printing

Mount for the AMD Stock Cooler (AMD Wraith Stealth) that hooks into the IKEA Skadis/SKÅDIS Pegboard. Does not need much infill and fits the cooler not too tight. It only sits on the mount so you can take it off at all times.

Shifter Knob USB Shifter

M8 Screw Spacer

Spacer for M9 Screws