Works great!

Really nice towel hanger ! I reduced the width of the hook to 16.50mm by cutting, moving one side, and merging back together because 20mm was too big. Would be nice if you made the model parametric !

Works really well! I used the 2mm profile and the only thing I could say is that it’s extremely tight. Maybe adding a bit of tolerance would be better. as you can see in the second picture the layers of the print start to separate when inserting the locking pin due to the really tight fit. You’ll need a hammer to secure everything in place.

The model is nice but the bottom lip is not high enough to prevent the phone from slipping. It would be better if the lip was higher and more square.

Keep the case firmly in place but it’s a bit complicated to secure. It doesn’t click in place I need to manually push the lever up and back down to secure it. I printed the back plate in PLA and the lever in PETG. I mounted it directly on the wall.

Works well! Adding water really makes it difficult for the dog 😂. Takes mine about 15 minutes. It also fits perfectly in his bowl (which is 8inch in diameter) so it stays perfectly in place.

Awesome design, it really fixes the ergonomic issue with the AppleTV remote. The remote fits perfectly and snuggly in the case, won’t fall at all. Only improvement I would recommend is making the bottom a bit rounder because now the corners are a bit pointy — would look better too. Also, I turned on fuzzy skin with 0.4 distance and 0.08 thickness and the finish is perfect providing more adherence.