Juno Yu

Ferfi.

I've created variants for 0.2 and 0.3 mm layer height. 0.2 mm version is sliced at 3.22 grams.0.3 mm version is sliced at 4.06 grams. The original BridgingTestMaterialSaving.3mf is sliced at 5.47 grams.There are four layers above the bridge layer and only two layers at the bottom pad. Happy bridging!

Bridging Test with less material

拓竹参数

DesignCraft

The AMS Lid Riser XL is big brother to the popular <a target="_blank" href="https://makerworld.com/en/models/33133" rel="nofollow noopener">AMS Lid Riser</a> and allows you to keep your AMS lid closed while using larger filament spools within the Bambu Lab AMS. The AMS Lid Riser XL provides an additional 10 degrees of clearance over the standard closed position of the AMS lid.&nbsp;Instructions:<ul><li>Print both sides of the AMS Lid Riser XL along with the tongues for each side.</li><li>Insert the tongues into the bottom of each side. While glue is not required I did apply CA glue to the tongues before assembly. Please make sure you're applying glue to the correct side as it only fits in one way.</li><li>Wait for the glue to dry before installing the AMS Lid Riser XL.</li><li>To install the AMS Lid Riser XL open the AMS lid, insert one riser piece at a time and firmly press the tongue into the rubber gasket, and close the AMS lid as pictured.</li></ul>Notes:<ul><li>Do not enable Flow Dynamics Calibration when printing or the part may overlap the lines.</li><li>It is not recommend to re-orient the position of the parts on the build plate unless you're an advanced user. They're positioned in this fashion to avoid warping that can be caused by close proximity to the fan.</li><li>Shown as printed in Bambu PLA Basic.</li></ul>

拓竹参数

拓竹扩展配件