the supports are extremely hard to remove. the hole in the frogs mouth is small and hard to get at the supports and then they are super stuck and hard to remove from inside the frog. once they were finally removed, the frog is great and a lot of fun. the stick to play it with fell over the first print so I added a brim and it worked well. I’ve printed 3 frogs so far. one at 100%, 300%, and one maxed out for my build plate at 425%! all has the same difficulty removing the supports.

The letters had issues and fell of during printing the first time. I removed the letters and instead added my own as embeded letters and it was good. I maxed out my build plate with this and my daughter used it for her school report.

I wish it would let me rate all of these. I downloaded the whole set and put them all on one plate and printed them at the same time. My son loves them! They worked wonderfully.

Worked well used a piece of filament for the hinge.

I maxed out the A1 build plate making the largest version of this I could. gave it to my nephew for his birthday. He loves it.

fun print. easy to personalize.

easy to personalize fun to have

loved these. I made a few for Christmas gifts. I used a LED puck (battery powered) to light them.

loved these. I made a few for Christmas gifts. I used a LED puck (battery powered) to light them.

loved it

I had issues with one of the legs not printing correctly. other than that it is a really cute model for Christmas time. I think the leg not printing correctly was my fault by not having a clean build plate.

First attempt I forgot to clean my build plate and made a mess, my mistake. after cleaning the plate this printed wonderfully and was a great tree topper.

made this as a gift for my sons preschool class. They worked great. all the kids loved them. unfortunately the antenna are a like weak and break off fairly easily.

this printed very well. we used the tight rings and probably would have been better off with the regular ones. we love it.

Good print fun to use the bullets can go quite far. The assembly is simple and easy. It is especially nice that the spring is easily accessible to replace if it gets worn down.

This works great and is fun to use however after using it for a little while it starts to get loose. Other than that good file.

I like having the tab to hold onto. It makes using these clips much easier. I also enjoy that they hold the filament so well.

This model was a little more of the grounds than I wanted. I only wanted the temple itself. I was able to cut the model and use negative modifiers to get what I wanted, but the model was also very detailed, and we loved the end result.

Great little toy to use up all the little bits of filament I have lying around.

Great Halloween decoration. I plan on printing several to use for Duck, Duck, Jeep. Printed without any issues.