Quite hard to print the glasses but OMG, it's soooo cute. Its got me so much in the good books with the boyfriend :) I did one print as it was downloaded and found that despite glue around the bottom/top it slightly leaked, and the bf prefers one that don't so he can water sparingly but often, and the glasses I had to repair as I broke them taking off the supports, so as I have a P2S and H2C I combined the top and bottom into a multi-colour and then put a small X-Y contour compensation on the glasses to make them really robust. I also increased the wall count to make sure it's water tight. I'm quite pleased with the result :) I'm loving the stuff Below3D creates because it's got everything you need to play and experiment which is the joy of 3D printing for me - I'm certainly learning at lot! Thanks again to Below3D for yet another wonderful model that you can have so much fun with 👍 I'll add my print profile to this so any others can see what I ended up with.

Excellent design. I put a small dab of glue on the handles, and to snap the hinges I eventually worked out you lay the hinge flat 'closed' and then just press from the rear. As the author says, unless you are an octopus then this is an invaluable addition to the Sun Lu splicer

Fabulous design again from this very talented person. The only thing is the hood strings are quite fragile as they are quite thin. Prints very well but be careful when you remove the supports as you can easily bend one. I've put a very small dab of glue behind them to secure them to the main body - you might want to do that or add a small modifier to make them attached. The 'fuzzy' one doesn't seem to have this issue as the fuzz makes them lay on the body just fine. Looks really great in the Bambu Baby Blue PLA Silk+!

Fantastic design. Printed in PETG Transparent for the main brackets, with ASA for the AMS HT tray, and printed the smaller bracket for the side above the vent as I have the filter coming for that. Only thought is that the AMS-HT tray puts the AMS very close to the side which means it interferes with the TPU spool holder I have (https://makerworld.com/en/models/1421552-h2d-flexible-filament-top-feed-rack#profileId-1477010) but that's a simple fix by just shaving off the R hand bracket of the top feeder.

Absolutely stunning design! Printed flawlessly on my H2C with 0.4 nozzle and 0.16 quality layer height. Matt filament best given the amazing amount of details. Printed the puffer bit in silk so it changes colour under different light (all these pictures are of the same print, the silver under GU10 bulbs, light blue in daylight)

Really nice desigb