had a little warping (my fault got to eager when it finished and didn’t let it cool completely). I also have a small issue with the linkage that goes around the Z axis upright, it comes out of the front J shaped piece. I will have to put a pin in it to correct this. Otherwise a brilliant idea especially as my A1 mini is in a corner between 2 walls

printed fairly well, printed 0.16 layer height. only issue I can see is that the wall above the outlet chute is very thin and has made a slight hole.

printed ok, was a bit tight but after my boy played with it for about 5 minutes it loosened up

printed really nicely. I printed in a dark grey to get a stone-like look

printed ok, was fairly tight but loosened up with lots of use. perfect for my needs

printed well. I needed to reduce it to 75% to fit my guinea pigs specific water bottle

printed really nicely even with a 0.4 nozzle. supports were a bit tricky to remove but left minimal scarring

printed amazing, my little boy loved it.

printed really nicely!

printer great. has some stringing but that was my fault trying an old filament