Jonathan Beaudoin

Outer diameter: 80 mmInner diameter: 70 mmTotal height: 106 mm

Small Cup with removable cover

Organisation

Outdoor Table Umbrella Hole Cover

Others

Simple serger spool.No support required.&nbsp;Fits on the Singer 14CG754 ProFinish and most likely other machines.

Serger Spool

Sewing

Scale 1:7Print the main part on its back.Glue the drawer faces to the drawers.

Doll House Drawers

Doll House

Plague Doctor Cane.Use a 19 mm (¾) wooden dowel rod for the cane.Print 2 Wing1 and Wing2 parts and glue together. I used epoxy and 5mm dowels.

Plague Doctor Cane

Costumes

Moriel

Taurus zodiac

Taurus zodiac

Decoration

Test Square&nbsp;Dimensions 40x40x10mm.5mm fillets on corners.0.8 mm chamfer on top and bottom surfaces.

Test Rounded Square 40x10mm

3D Printer Calibration

Modular race track for hotwheels.The ramps require support to print. Everything else doesn't require support.

Race track

Toys

Simple fillet gauges.Metric from 13 mm to 26 mm.If other sizes are needed, just ask and I will happily model them for you.

Fillet Gauges

Tools

A small cup to hold a dish brush while it dries. The hole lets the water flow to the sink.Use a heat gun to fold the waterfall along the crease.

Dish Brush Cup Holder

House

Lid riser for the P1S with integrated collapsible vents.Required Material without vents at the back:<ul><li>Printed parts:<ul><li>Blind A x3;</li><li>Blind B x3;</li><li>Front Right x1;</li><li>Front Left x1;</li><li>Back Right x1;</li><li>Back Left x1;</li><li>Knob x6;</li><li>Tongue x4.</li></ul></li><li>Hardware:<ul><li>M3x12 Buttonhead screws x6:<ul><li>For the knobs;</li></ul></li><li>M3x12 flathead screws x16;<ul><li>For the tongues;</li></ul></li><li>M3 nut x22.</li></ul></li></ul>At first, I did not put vents at the back. They would have been a pain to reach in order to open and close the vents on my setup. If you want vents at the back, you will need these additional parts:<ul><li>Printed parts:<ul><li>Back Right with vents (replaces Back Right);</li><li>Back Left with vents (replaces Back Left);</li><li>Knob x2 ( 8 total);</li><li>Blind A x1 (4 total);</li><li>Blind B x1 (4 total);</li></ul></li><li>Hardware:<ul><li>M3x12 Buttonhead screws x2 (8 total);</li><li>M3 nut x2 (24 total).</li></ul></li></ul>

BambuLab P1S Lid Riser with Vents

Small piece two connect two pieces of PTFE tubes with 4 mm outer diameters.Requires 2 collets.