Very creative design!

the hooks for the rubber bands are very small and even with an appropriate rubber band did not have a firm hold on my phone. this issue was compounded as the phone inside a.protective case is too thick for the provided jaws. I will adjust and reprint those parts. the bayonet has a keyway its full length, but the female receptical is only half the length requuring a cut and trim to be made to be able to seat it fully. other than that, I found the thumb on the screw to be small and tightly positioned. dont get me wrong, this is an incredible print

Strong

These are nice strong hinges and well strengthen. As with any print, I wish the screw size was included in the description. I am more comfortable with these hinges' durability than many of the thinner models offered. I would choose these.

These are nicely designed and fit well

These are nice boards, The connectors all went in but they are super tight and i had to press them in with a pipe. But the work was well worth it,

Cute print.

I got these guys down to 9mm. Used a support blocker around the legs. .2 nozzle, geeetech skin colored PLA

Great Print. I did notice I had trouble with the body. Specifically, the arm that rests in the raft support. I increased the model 30% prior to starting the print. What I believe happened is the minimal separation between the 2 parts did not stay constant at whatever the gap is and as a result the elbow was basically lose enough to start coming undone. Rather than fooling with it, I just added a brace on either side and that resolved the issue.

I printed off 20 and am going to use them as cage feeder door latches. I did extend the handle and added an end for ease of use. I left the color change in place for a visual cue.

Nice print

Screw holes seem a little too small

This was a great model. I think some additional tweaking could be done to make tree supports come off even easier, yet with that said, I was able to remove all the supports fairly clean. Two supports, both supporting hir locks, one in the back of the head and the other under the lower left side snake require particular attention. On the right lower snake, it appears AI has given it an arm and a foot. 5% infill, Geeetech "Like Marble Grey" PLA.

This was a good print. The arm, as described is delicate. I printed the ropes vertically which was challenging, but a learning experience. It does allow for a better-looking rope than had it been printed on the bed; however, it also weakened the part strength, I think a better print would be about 30-degree angle to achieve both strength and appearance. The big body section is a large raft to hold the rest of the upper body off the plate when printing. You should remove that immediately before it hardens up and becomes very difficult to separate.

The only issue I had was the gun part with the trigger. The print failed 5 times. I finally moved one 90 degrees from the other one so they both were not in line with each other, and it printed. Also noted, the upper right-hand plate is named Skin, however it needed to be named black. It was the plate with his shoes. (I accidently changed the entire plate to one color early on). You have great models!

ctually I chopped it up and made the coal load a tender cover that was missing.

Printed well

I resized them for 3/4-inch EMT pipe. Works like a charm. Not sure what the percentage was but the final size numbers to achieve the 3/4-inch EMT pipe are 29.3788 x 73.0943 x 25.4832.