cute but sits weird on the cup

so cute

this turned out perfect. thank you

works perfectly for my McDonald sauce addiction

I made these for all my patients. they loved them!

perfect. thank you

turned out great. thank u

printed these on my A1. just followed the same directions. seemed to have worked fine. thank u!!

I tried to print this twice scaled down to 75 percent. it would almost complete the whole print and then when it got to the top (which is the bottom of the tree) it had adhesion issues. the tree was removed in the photo below. see photos of the bottom of the tree. not sure it it was a me problem or the file. just thought u should know. used bambu A1.

I made it again but took my time with the melting of the middle piece and it looks much better

I scaled it down a little bit and the pieces aren’t an exact fit (I scaled them down to the same percentage). regardless it’s a cute fast print. thank you.

super cute. I may print a few more for my dining room table. printed without any problems. thank you

great print. I wish i wouldn’t of had to use a piece of filament to hold the numbers on as it doesn’t feel super sturdy, the numbers aren’t 100 percent even when up (see photo), and the sides where I melted the filament don’t look the best, however this was a fast easy print and the game works as it should.

I scaled this way down for my daughters little hamsters. it worked perfectly. thank you.

I scaled this ALOT. I wanted to make ornaments for my oak tree outside for this Christmas. At such a large scale the filament was stretched too thin and it has holes in it. this is my error not the designers. I am still on a mission to find large light weight low filament ornaments but if you need regular sized ornaments this is the way to go. beautiful print just wish i could get it to work scaled up.

As a newbie to the 3d world this took some time to figure out but I was able to get it to finally work. I used wood pla and somehow changed the settings to only print on the top and sides so the bottom was not wood grain and the print time was only 8 hours. (it was 22 hours when I started). I love how this turned out. thank you for the and here is a boost for sharing.

Turned out great. I did break one of the attachments and had to reprint one number, just be careful when attaching.