Printed fine no issues there. The only thing is I wish it could lock into place somehow. if I move my keyboard they easily go inward.

Pretty simple and easy print. No issues.

Printed beautifully without any issues! Great design.

Printed beautifully without any issues! Great design.

After generously donating an unknown amount of filament to the trash gods, I finally got the bearing in without snapping the rod/stem/thingy clean off. Attempt #1: Pretty sure I wasn’t even touching the rod… it broke anyway. Cool. Attempt #2: Was 1000% confident my hands were nowhere near the rod. Holding only the edges, gently tapping it on the counter like a responsible adult… snapped again. THEN I did the thing I should’ve done from the start: read the comments. PLEASE. I BEG YOU. READ THE COMMENTS. HEAT IT. Grabbed a blow dryer, went slow—heat… push… heat… push… and finally got that bad boy in. No breakage. No trauma. Will it stay attached long-term after being heated? TBD. But honestly? Still better than watching it snap off for the third time. 🫠

The parts you need to remove actually cut off very easily. I expected it to be more annoying, but they came off cleanly. The print quality was excellent. I printed the modified version with the angel at the bottom, and it turned out great.

the screwssssss I can’t get a lot of them to turn into their slots correctly (yes I know the top screw is counterclockwise can’t get that one in either) ughhhh

10/10 would print again (totally printed again).

it’s cute and all, but it doesn’t really move around like some of the other fidgets of its kind. it’s basically just good for that noise most people seem to like.

Turned out pretty cool. Used dual colors black/blue and just a solid black for the eyes.

Easy, problem free print. Printed with dual color orange/red.