It came out nicely. However, it doesn't look as clean as I had hoped it would. Part of the reason is probably that the PLA I used is wet the other is probably because the model is printed upright instead of lying flat on the build plate. But it works. If you want something that might have a cleaner look, I suggest you try this model: https://makerworld.com/models/1859589 I used the following lithium polymer battery and M2x12 screws: Battery https://amzn.eu/d/g32uRrM Screws https://amzn.eu/d/aKEOeiJ

Thank you for these clamps. Print came out great. I used them to glue my phone back together.

Came out great. Thank you for the profile!

Works!

These printed just fine. They were really useful and in my opinion even better than the ones you get with dissasembly kits since the edge is thinner. I printed them in Bambu Tough PLA. If you are careful during the dissasembly of your phone you might be able to reuse them. Almost all of mine are now bent and I'll have to print new ones if I have to disassemble a phone again.

Great for when you quickly need a box for anything really. Especially useful for cleaning up an electronics space.

Probably one of the best and nicest looking organizing trays ever. Print turned out great. Printed in BL PLA Bronze and BL PLA (some kind of) Blue

Great soap dish. Have been using this one for over a year now. Had to scale up the original model about 50% or so in order for my soap bar to fit nicely.

Needed a box to put unused / failed prints into. Great print quality

Love this design! Turned out great on the Bambu X1C using a 0.4mm nozzle. If I were to print these again, I would probably use a 0.2mm nozzle to increase surface quality

Printed on a BambuLab X1C. They turned out great.

Print quality is great, as usual with BambuLab printers. Just had some stringing because my PLA has attracted some moisture.