getting the legs on was a pain in the back side. but over all great print.

this works flawlessly.

printed out 34 of these for my wife's classroom. they came out great.

printed great out of pla. but way too brittle. I have petg on the way and some ppa-cf I'll try next.

don't hesitate to print this. its nice and flat corner to corner. Great way to make sure th side springs are set properly and motor wires arnt pulling the pod one way or the other.

I dont know if it was my fault for changing something or if it was the print. the large hinging in the back was way too tight.

a must have if using the ams. keeps my ams at 10% here in Florida where humidity can be 100% and due point can be over 80.

fits perfectly.

great tool. measurements are close enough for what it's used for.

awesome little storage box. great for the small screws I use for mini z.

This dragon is awesome when printed in two colors.

printed well, printed even better with supports turned on. they seem strong enough printed out of normal PLA i don't feel the need to print them out of any of material.

Great little clips that work, print was easy.