came out really nice

1 corner misprinted, looked to be due to 1 of the corners started doing the top layers half way through then picked up again with infill and threw it around a bit but other 3 printed well, I should have paid more attention after slicing, other than that all good.

supports are a bit too attached, I would change a couple settings for supports if I was to do it again, with care taking them off be fine, 1 of 4 I printed is missing a skadis attachment due to taking support off like I normally do and snapping it, other than that good dimensions and no "click in" which is what I was after

Really cool model, with tpu95 it gives a bounce, not as much as an actual tennis ball but the cool factor is worth it

worked well, thanks, very tight fit

turned out really good, with 0.1mm thickness and length on fuzzy skin it gave even more grip, thanks

great laugh, lil bit big for my cat but he is not fully grown yet so rather than resize I will wait, got some great pictures regardless, thanks