Great design, super cute. eyes are a bit difficult to match up and install.

great in place design, but I keep getting poor quality on the top legs since they’re unsupported bridging. maybe rotating the top legs out would allow supports to improve the surface quality?

great design, but one little section where the bird meets the flowers is extremely thin and bent when removing off th build plate

Great design to lift up the ams out of the way. I use mostly PLA and made a slim fitting light frame to help the on board led light and it fit great. also have a ring cam with an aerial view now that it cleared up the p1s top lid. finding the m3x30 screws was a PITA. sold out everywhere but found 45mm at hardware store and had to cut them down.