I was slightly concerned about these based off of the print quality in some of the designer’s photos. They must have used some sort of draft settings, though, because when I printed them, they were FLAWLESS. I did change a couple settings to better fit my detail and brim preferences. I printed the 28 mm model (9 per plate) using an X1C. I changed the print to 0.12 mm high quality for finer detail. I also changed the brim gap to 0.3 mm to reduce the likelihood of needing to deburr such a tiny print. they’re amazing! My kids are going to love them for their little Sylvanian toy shopping mall. Thank you!